BARRACUDA

Point

It is a point to put out the roundness of the bonnet well.
Please bend the part put from the side on the upper surface gradually without folding.

Nature and the width of the car are decided when overlap width in the upper surface part matches it to come in succession well, and paste it politely, please. 21321h71v

I think that it becomes difficult to make at all when the order of sticking together is different.

To produce it with copy paper, it designs. Especially, thick paper need not be prepared.

Because Tairo is good if it is an inkjet, special paper, it finishes beautifully.

Please it is not thought that the position where the rear wheel part is cut is understood easily, and see right figure, and cut the part in a red line.

First of all, it sticks it together from the lower side of the back.

The upper surface of the fair ring is started from the nose side, and it sticks it together to the second panel.
When the second is pasted, overlap width is made to come in succession well while adjusting the swelling addition and subtraction.

The lower side of the nose and the nose point are pasted.
At this time, the part that becomes a front wheel is folded, and set up.

The third upper panel is pasted. According to points similar to the second.

Sideward of the canopy is valley case. It pastes while straightening shape, and the swelling of the canopy is made.

Overlap width pastes the upper surface part to come in succession beautifully noting it and it shuts.

Overlap width at the rear end is pasted at the end and the completion.